-
Hello,
I just tried out connect Node Red to Fanuc robot controller, but there are needed more informations to configure protocol. This is list of these parameters:
- Vendor ID
- Device Type
- Pro…
-
### systemd version the issue has been seen with
255
### Used distribution
Ubuntu Desktop 24.04.1 LTS
### Linux kernel version used
6.8.0-41-generic
### CPU architectures issue was s…
-
Hello,
We plan to heavily use netmap in our robot company (we develop an Ethercat master). This is the best project we found so far to skip the kernel when sending/receiving network packets. Unfortu…
-
hi,
I need the hardware to compile and run with idf version 5.xx i want o use IDF5.14 and IDF5.3x .
After selecting example project "D:\esp-idf-v5.3.X\examples\ethernet\basic"
idf.py set-ta…
-
Greetings,
Inspired by my previous [idea](https://github.com/gilesknap/maaspower/issues/21), I believe that a RESTful type of device control could be more useful.
The added benefits versus the S…
-
### Description of the problem
> Replace this line with your answer.
### Description of your products
> - the product name of your NAS model
> - and output of ``uname -a`` command
> …
-
I want to add 2.5Gb ethernet card to my chromebox. I added it and it doesn't work.
Some information about system:
firmware-util.sh output:
```
** Device: Asus Chromebox 3 / CN65 (TEEMO)
** …
-
Hi, I have a KSZ9567R connected with Jetson AGX ORIN trough RGMII and i2c. I have modified the .dts as follows:
```
#include
/ {
eth0:ethernet@2310000 {
status = "okay";
nvidia,pause_f…
-
### Describe the bug
I have flash latest snapshot to my Rock64 SBC.
SD: working as expected
EMMC: not working
I attached log below:
```
U-Boot 2024.07-OpenWrt-r27300-e7ea93e1e3 (Sep 05 2024 - …
-
### Describe the bug
Hi,
I am running OpenWRT snapshot on FriendlyElec NanoPI R6S.
I have noted that `eth0` card (RTL8211F Gigabit Ethernet) is not working properly with VLAN configuration.
Ma…