-
Hi,
Thanks for your work on FutureSDR and seify!
Looking to contribute a rust based driver for the HackRF One, and wanted to make double check the approach.
I'm assuming following what the rtl sd…
-
I'm running a HackRF and an RTLSDR side by side with two different antennas. RTL_433 is running on both simultaneously and says it picks up both devices, but I can't get any readings out of the HackRF…
-
sorry to bother you with a perhaps not the most intelligent question, but I'm new to using macOS. radioconda installed without errors (m2 max sonoma 14.6). however hackrf is not detected at all. I hav…
-
When I write the following command:
`./gal-osnma-sim -l 31.1598,131.1589,100 -v ./tv/configuration_A/13_DEC_2020_GST_09_00_01_fixed.csv -b 8 -d 60 -k`
The following output appears and freezes on the…
-
### Have you read the HackRF [documentation](https://hackrf.readthedocs.io/en/latest/)?
no
### What outcome were you hoping for?
Bought two HackRF One. One them is not working. Signal transmitted f…
-
### What happened?
I can't detect my HackRF on any Computers to use a batch file or even a cmd prompt to flash the new updates
### Your hardware
Portapack HackRF One H2
### Tests
- [X] I managed …
-
I am successfully working with qspectrumanalyzer and other tools for hackrf, but SigDigger was showing me nothing. After some investigation I found that it just drops GHZ digit, so when I am receiving…
-
thanks for speaking at 34c3 and creating this tool. it would be nice to have hackrf_sweep integrated.
-
The screenshot is pretty self explanatory, I didn't change anything and I couldn't find anything in the logs. This doesn't just show up in the FFT but also when double checking with an other SDR. I tr…
-
If I put my portapack into hackrf mode and try to run hackrf_sweep_spectrum_analyzer under windows 11 it does not work.
it only works when I use firmware hackrf-2018.01.1
other software eg. sd…