-
-
Like the TOP 30/375-2 ZBS
-
- Hardware: Teensy LC with ENC28J60 LAN module
- Software: Configurable Firmata 2.8.0, UIPEthernet 1.09
- Active Features: digital outputs, I2C, serial port
Operation is as expected until a LAN disco…
-
### Discussed in https://github.com/emsesp/EMS-ESP32/discussions/1195
Originally posted by **g6094199** June 23, 2023
Hi,
i have to ems-esp (with different names an different heating system…
-
How difficult would it be to have EMS-ESP to emulate real thermostat?
Why: I dont have any thermostat at all. I have a smart home where are radiator valves are electronic and controlled independently…
-
Just installed a BbqKees Gateway Premuim II (P2) with my Junkers Ceraclass Excellence ZSC 28-3 MFA E 23 boiler.
It detects the following devices:
- Boiler, Condens 2500/Logamax/Logomatic/Cerapur Top…
-
Hello,
my ESP-EMS show information about unrecognized device.
Output from scan command:
**Setup:**
- Junkers ZSBR-16-3 (heatronic 3, connected via bus)
- Tado extension kit (the [older ve…
-
I want to add support for writing to the thermostat Junkers FW100 (e.g. change the room setpoint temperature), but I cannot find the telegram type that is used to write to the thermostat.
When I c…
-
Hi!
Currently I am using the hometop HT3 software for monitoring my Junkers heating system. Now i‘ve discovered this system and want to implement it with my HA setup too.
Has anybody managed to …
-
edited for boiler->thermostat mixup
I have a CW400 thermostat with 1 heating circuit recognized as:
```
Thermostat: RC300/RC310/Moduline 3000/CW400/Sense II (DeviceID:0x10, ProductID:158, Version…