-
Hi,
Nice work on figuring out the iRT protocol! I want to monitor my EcomLine Classic HRC30 UBA4000 (1997 o_0) with Moduline 300 thermostat so I made a circuit that listens to the bus using a seri…
-
Hi,
The RTP Tools website is displaying an error:
https://www.cs.columbia.edu/irt/software/rtptools/
Additionally the status code is 200 but also has a 404 `status` header:
```
~ $ curl -v ht…
-
Dear Victor,
I'm trying to compile the firmware with the help of Gitpod.
I'm famliar with Tasmota and it works pretty easy to run one's own compiled firmware in Gitpod.
Is there something simil…
-
Apparently some devices don't close their replies to our commands/queries with the expected (and mandated by the specs) CR and, at the moment, this is not supported by nutdrv_qx:
http://lists.alioth.…
zykh updated
5 months ago
-
I managed to install on my Wemos D1 mini with the help of the "trick" referenced below.
Then I can connect to the WiFi AP, and open the web interface, but it does not respond to any setting I try t…
NiekD updated
2 years ago
-
## What is the proposed Cheat Sheet about?
The proposed cheat sheet, titled "Incident Response for Web Applications," aims to provide a practical guide for handling security incidents related to …
-
As seen on #2014, some people also disconnected with some “Server command overflow” log on server, something the RmlUi Lua GC bug did not reproduced:
```
ELCOCO1981^* Server command overflow
```
…
-
Hi CAPI people,
I would like to create an app with multiple app ports and attached routes. I don't wont to go the extra mile by calling several additional CLI commands but instead have the support …
-
### Describe the issue
In relation to a recent email discussion, I had a look at https://datatracker.ietf.org/doc/draft-duerst-dns-i18n/, and discovered that it shows the numbered drafts in the wrong…
-
It's a little unclear whether `nvi` is supposed during image building, by installing Node.js *into* the image, or inside the container itself after build time. In case of the former, I think the parag…