-
This is a very weak lathe. Be sure to check all attachment points and secure to spindle with more than friction. Go slow at the beginning. The direction of spin makes the object fly away from you mos…
-
Hi.
I made some tests with BlackPill (411, firmware from Web Builder) connected to two generators, one 3200 Hz as pulses, and second 1 Hz short pulses as index.
I surprised the G33 (and G76 too) wo…
-
for example, there are A, B, C and when I want to make A, it would make A or B or C
But the recipe and the result are still one-to-one, for example, if my recipe is A, then it will definitely make a …
-
I was Changing the Recipes for the Lathe Machine.
For Example:
mods.industrialrenewal.lathe.addRecipe(,, 120);
JEI shows the Right Result.
But when i craft it in the Lathe Machine the Output is:
…
-
I've been eyeing doing this for a while, but there's a hardware roadblock:
* Low-cost lathes which are rigid enough (e.g. my Sherline and bench-top Chinese lathes) have backlash which is too large …
-
Is there a way to implement lathe volume cutter, i.e cutter will remove material as its swept volume around X-axis, like a toroidal volume?
-
Just wondering if anybody else experiencing this. Set my controller to 8tpi on slowest spindle speed, turned spindle speed to maximum servo matched speed. When I turned speed back down servo kept r…
-
Guys,
wondering what is the max spindle encoder pulses per second that can be processed by TI microprocessor hardware? I can see nice magnetic encoder rings available. The one that is big enough for …
-
Hi @elimoss
I am using your tool for assembling my long reads metagenome. I have a doubt in the procedure of assembly that does the lathe also bin the genomes before doing the circularization or do w…
-
Hi,
Should in the subroutine folder be a turning.ngc file?
Because the turning tab in conversational tab doesn't do anything.