-
Hello,
I have flashed a brand new tinybee with the firmware build on the webbuilder, config in lathe mode, no option, no wifi, nothing.
Just two motors, Z and X, no limits.
Reset params before te…
-
Hi
When try to use Touch off button with X work fine
Try with Z don't work, error reported Bad character 'u' used
Br
-
I don't have a real problem per say other than I'm not a good programmer. I see so many other uses for this system other than driving the lathe leadscrew, which is what my first ELS has been doing suc…
-
Hi
Hi have this problem with your release for lathe, if selected lathe = 1 from file main.ini the standalone tab DRO is not updated anymore.
Remove lathe = 1 make the DRO tab work fine.
This i…
-
In Lathe mode G71 introduces a half circle when using the D parameter, it disappears when not using the D parameter.
I'm using the latest linuxcnc git version (15. March 2024)
G17 G54 G40 G80 G90
…
-
use linuxcnc 2.9-pre-0 on uspace.
System Debian 10
-on lathe configuration with x-y-z and 2 spindle , when use X axis for life tool spindle use g19 plane.
the machine have limit on x plus 600mm and…
-
How hard would it be to add a slotting mode? For example, for broaching an internal keyway using tiny infeeds of the cross slide, and moving the carriage left and right.
Example:
https://youtu.be/…
-
I have spare input in esp32 board. can I use lathe mode with esp32 if yes then kindly inform me how to set gpio pin for spindle encoder.
I am using 1.5 kw servo as a spindle which can do both operati…
-
A little quality of life suggestion. I've modified my setup to start up in metric mode as I have. Metric lathe, but the firmware could determine this based upon whether a metric or imperial leadscrew …
-
How about adding a motor & controller for the cross slide?
Software modifications needed would be quite easy task.
The spare Settings-button could be used to switch the feed mode.
ELS is probably m…