-
is it possible to run it on a smoothieboard or lpc1769/68 board
-
## LPC1769 Modules Used in the Project
For this project, the following modules of the LPC1769 board will be used:
1. **GPIO**: Will be used to connect a 7-segment display, which will show the co…
-
I'm curious if it is possible to get QEI or spindle sync working on LPC1769 board like the SKR turbo. I see that the chip itself does support QEI.
-
## Component list
- Motor.
- LM35 Temperature Sensor.
- HY-SRF05 Ultrasonic Sensor.
- 3 buttons.
- Red LED.
- USB to RS232 converter.
- Resistor 1K Ohm.
## Schematic
![PepsiCity_Scheme]…
-
En este apartado buscamos exponer todo lo relacionado con el Hardware de nuestro proyecto, se incluira un diagrama esquematico que muestra como se conectan los componentes con la placa, como asi un li…
-
Trying to compile Marlin latest bugfix to enable dual z axis. I uncomment :
#define Z_STEPPER_AUTO_ALIGN
and when build it fails with the following error:
compiling .pio\build\LPC1769\src\src\H…
-
Hello,
I'm trying to create an Ender-5-Pro Firmware for my new BTT SKR E3 Turbo mainboard and BLTouch as instructed here:
https://github.com/bigtreetech/BIGTREETECH-SKR-E3-Turbo
**Did anyone go…
-
As suggested, I've selected to use
//
// RepRapDiscount FULL GRAPHIC Smart Controller
// http://reprap.org/wiki/RepRapDiscount_Full_Graphic_Smart_Controller
//
#define REPRAP_DISCOUNT_FULL_GRA…
-
I have a issue with Compiling this Firmware for a org. Sapphire Plus.
Only i have change is the Board, to a MKS robin nano V1.X and Bltouch is pluged on Zmin_pin.
This is the Error for Compiling:
…
-
Do you know how to make the Fysetc Mini 12864 to work with the TH3D-EZBOARD LITE using their unified firmware?