-
KS0 Ultra Standard fan replaced with 2x "NOCTUA NF-F12 5V PWM"
(Tunnel structure for cooling)
Updated KS0-Ultra stock firmware -> pbv080_ks0ultraupdate.bgz
All working fine for days with Fan Co…
-
**Describe the bug**
Noctua PWM fans typically require a target frequency of 25kHz. Regardless of the PWM frequency specified, the maximum frequency is 5.367 kHz as measured with an oscilloscope. …
-
Currently setting up the correct lower and upper values can be somewhat error-prone as #28 demonstrated, it would help if SMFC did this job of configuring the IPMI fan upper and lower bounds for us in…
-
As there is no dedicated port for pwm fan with four pins, i would like to know if it is possible to use PG10 to control my fan ?
https://noctua.at/en/nf-f12-industrialppc-24v-3000-sp-ip67-pwm
I beli…
-
As soon as the Hotend fan is running I get permanent "Some problem encountered, Z-Leveling enforced". This happens when 3 or 5 calibration attempts are selected in the calibration menu. I am quite sur…
-
**Describe the bug**
Periodically (and seemingly randomly) Fan Control looses all settings: sensors linked to curves, mapping of fan controls to sensors, mapping of fan controls to curves, names of t…
-
I've moved my X11SSL-F board to another case and equipped it with lower quality NF-P12 redux-1700 PWM (previously used NF-A12x25). On some boots the IPMI complained about too low and too high RPM erro…
-
**Describe the bug**
The actual RPM of a fan that is controlled by fan2go doesn't match the linear fan curve defined in `/etc/fan2go/fan2go.yaml`, the actual PWM value always seems to be a certain am…
-
When the wifi haa a timeout `wifi:bcn_timeout,ap_probe_send_start`, it tries to restart the socket and stratum connection, but some bits are left in a wrong state resulting in the device hashing but a…
-
Description:
I have a fan connected to my AIO Pump header, but I can't see any data (Fan RPMs, Percentage) for it in the hardware monitor. I can see this data through the BIOS.
My Setup:
ASUS R…