-
Please I need help when I Upload in the Pro Micro Leonardo it gives me an error, why ?
```
Sketch uses 24540 bytes (85%) of program storage space. Maximum is 28672 bytes.
Global variables use 1638 …
-
We'd apparently need to bundle [AVRDUDE](http://savannah.nongnu.org/projects/avrdude/). [Here's a reference on how to use it with the Pro Micro.](https://deskthority.net/workshop-f7/how-to-use-a-pro-m…
-
Hello author, I like TPS42 designed by you very much, and I am trying to make it. However, when choosing the master, I found that the generated firmware is much larger than the memory size of Atmega32…
-
Hi @rrevans, I am trying to use the bootloader with Pro Micro clone.
Here the procedure:
- `config.h` with default `VENDOR_ID` and `PRODUCT_ID`. Using `OSC_MHZ_16` and no LEDs.
- Setting fuses wi…
-
I have a slight problem trying to upload to a fresh sparkfun "pro Micro" if I set it as Lenoardo. It sees it starts programming and then gets stuck at 88%. And it bricks the pro Micro. I had to rebur…
-
https://www.youtube.com/watch?v=UnIa2jbEHRk
SparkFun Pro Micro RP2350
The RP3250 is a unique dual-core microcontroller with two ARM® Cortex® M33 processors and two Hazard3 RISC-V processors, all r…
-
### Cura Version
5.9.0
### Operating System
Linux
### Printer
Creality ender 3 s1 pro with klipper
### Reproduction steps
Downloaded ultimaker cura 5.9 linux on my chrome desktop and can't put…
-
I have a board that is not detected, please add it to MobiFlight with this information
**Provide the VID / PID combination**
Check the device manager for this information
VID: 0x2341
PID: 0x8036…
-
If I could get a presoldered Qwiic Pro Micro, it would make production a lot easier (I'm bad at soldering) .
-
**Describe the bug**
`pxt deploy` reports `Error: cannot find any drives to deploy to` even though the micro:bit is connected and working well in MakeCode online.
**To Reproduce**
Steps to reproduce …