-
Hi, is it possible to change the state of one of the Raspberry Pi GPIO pins when prey is detected?
-
It appears that GPIO has changed with the Raspberry Pi 5. It would be great if you could update this module to support the RPI 5.
-
I use a ENC424J600 ethernet controller connected to a RPi Pico. The Pico also should generate the 25 MHz clock for the ENC424J600. In Zephyr v3.5.0 I used a PRE_KERNEL_1 SYS_INIT and the RPi Pico SDK…
-
## Motivation
Currently, the Python hardware controller is unable to run on the Raspberry Pi 5 - it depends on the `rpi-gpio` package, which does not work on the Raspberry Pi 5 (see https://adafrui…
-
Beta version of snap, following [Wiki](https://github.com/canonical/matter-pi-gpio-commander/wiki/Setup-and-control-a-lighting-device):
```
$ sudo snap install matter-pi-gpio-commander --beta
matte…
-
I try to connect the pi-fancontrol to the gpio.pin 14 as described in https://snapcraft.io/install/pi-fancontrol/opensuse
# snap connect pi-fancontrol:gpio pi:bcm-gpio-14
error: snap "pi" is…
-
Hi,
I upgraded my raspberry pi 4 to bookworm and kernel 6.6 and even if the GPIO pin 17 is triggered the clean shutdown down does not respond or shutdown the raspberry pi anymore.
I also changed th…
-
Hi
I am trying to understand how to configure the pins on the Waveshare 2.8inch Display Module for Raspberry Pi Pico to access the onboard SD card using your driver (SDIO).
The Pinout Definition o…
-
I had a projet with this library and It was working well last year. Now I'm setuping a new raspberry pi with Raspberry OS Lite 64 bits and I got this error:
Error: pigpio error -123 in gpioSetISRFu…
-
The software uses the RPi.GPIO module to access the GPIOs. This module seems unmaintained, the last release [0.7.1](https://pypi.org/project/RPi.GPIO/#history) was on Feb 2022.
One [known issue](ht…