-
Hello. First of all, Thank the developers team for this fantastic repo.
Unfortunately, I'm unable to find the **Respeaker 2 Mic Pi-Hat board** in my region. Is it necessary to use this specific boar…
-
Anyone here using https://github.com/furushchev/respeaker_ros ? I'm using it, mostly with success, but most of the time the first time I launch it, it fails to correctly find the respeaker device. If …
-
* [x] install re-speaker 2 mics hat to a rpi
* [ ] explore seeed respeaker docs, wiki
* [ ] run basic examples
* [ ] document any issues here
-
Hello,
I have successfully connected the ReSpeaker Mic Array v2.0 to my Android device and would like to utilize its features, such as far-field voice capture, voice activity detection, direction o…
-
Explore options for implementing voice control of the robot. Document potential technologies and frameworks for integrating voice commands with the robot’s control system.
-
Hello,
I'm stumped...
> `wyoming-wakeword.service - openWakeWord
> Loaded: loaded (/etc/systemd/system/wyoming-wakeword.service; enabled; preset: enabled)
> Active: active (running…
-
I think the pinout diagram (https://pinout.xyz/pinout/respeaker_4_mic_array) shown for this board has some errors.
They are associated with the 4 pin JST connector the Seeed people refer to as "GPIO1…
-
I'm running my wyoming satellite on pi zero 2w and a ReSpeaker 2-Mics, which has a physical button.
Can it be possible to assign a feature to it, or at least expose it as an button entity? For exampl…
-
I have installed everything in the guide on my raspberry pi 3b+ and did the asound.conf. If I run
"./ec -i plughw:CARD=seeed4micvoicec,DEV=0 -o plughw:CARD=seeed4micvoicec,DEV=0 -d 200 -s"
This is…
-
Hi,
I finally received my Respeaker: it is a MIPS processor running OpenWrt, so Jarvis will not work out of the box. Others might try the same thing so this thread is to share our experiences.
I…