-
**Goals **:
**DNN Debug**
- [x] Add scan chain and DNN on the same routine (next best thing before we get the new FW from Cristian)
- [x] Test a few clusters and see if it changes
- [x] Create …
-
**Expected Behavior**
All I've been trying to do is build & install Yaru with a modified color palette, expected ninja install to operate without issue.
**Actual Behavior**
It builds fine but…
-
A VHDL simulation initializes value of signal to `type'left`.
This may sometimes hide bugs on RTL, that later pop-out on GLS.
An example is FSM coded with enum type and first state being `S_IDLE`.…
-
Hi
I have Pyton 3.6 32bit (My CPU is intel i7)
NooElec RTL2832U & R820T RF key
PothosGUI vc14-x64 (Cubic SDR work well)
Zadig 2.3 (Bulk-in, Interface (Interface 0) -> WinUSB (v6.1.7600.16385)
…
-
```
What steps will reproduce the problem?
1. see http://www.rtl-sdr.com/new-command-line-utility-rtl_power/
2.
3.
What is the expected output? What do you see instead?
n/a
What version of the produ…
-
```
What steps will reproduce the problem?
1. see http://www.rtl-sdr.com/new-command-line-utility-rtl_power/
2.
3.
What is the expected output? What do you see instead?
n/a
What version of the produ…
-
When starting Satdump in CLI or GUI mode on the Raspberry Pi, the starting frequency isn't correct. In the GUI, when you change the frequency the SDR sets to the correct frequency. The CLI version can…
-
```
What steps will reproduce the problem?
1. see http://www.rtl-sdr.com/new-command-line-utility-rtl_power/
2.
3.
What is the expected output? What do you see instead?
n/a
What version of the produ…
-
```
What steps will reproduce the problem?
1. see http://www.rtl-sdr.com/new-command-line-utility-rtl_power/
2.
3.
What is the expected output? What do you see instead?
n/a
What version of the produ…
-
```
What steps will reproduce the problem?
1. see http://www.rtl-sdr.com/new-command-line-utility-rtl_power/
2.
3.
What is the expected output? What do you see instead?
n/a
What version of the produ…