-
Work in progress...
https://github.com/wallarug/seesaw
More complicated than I first thought.
-
I would like to use the Metro M4 as a remote controller run by a master microcontroller. I need to read A/D results and send D/A levels as well as set logic pins. I am worried that the I2C and RX/TX l…
-
Any work being done to add support for the SAMD51??
-
I was wondering if the SAMD51 might be an interesting target for the future?
It is also a SAM architecture but based on Cortex M4, its cheaper and seems more "powerful" than the SAM3X the Due uses.
…
-
HI, thank you very much of this great project. I would like to report an issue where the pack command couldn't find the SAMD51 target although it is listed in the offical pack https://www.keil.com/dd2…
-
Board = PyPortal Titano (SAMD51 with onboard ESP32)
Uploaded the [SerialNINAPassthru sketch](https://github.com/adafruit/WiFiNINA/blob/master/examples/Tools/SerialNINAPassthrough/SerialNINAPassthroug…
tyeth updated
4 weeks ago
-
Hi,
The implementation for the samd servo library doesn't work on samd51.
The syncbusy bit and clock management are different on this new chip so the code [here](https://github.com/arduino-libra…
-
The DAMD51 provides dual banks to upload firmware. E.g., the current firmware is located in BankA and the new firmware is saved in BankB. After uploading the new firmware to BankB switch to start firm…
-
``I have a data logger that takes in inputs from 2 ADCs and writes them to 2 circular buffers using DMA. This part works well. I am able to read data in and get it to the buffers at about 2.4 Mb/s.
…
-
update1:
Problem solved, please see my last message in this string...
I expect this is also an issue with SAMD21 CPU chip...
update:
If I take a new processor chip, and run the program, it fails…