-
more Sensors and ESC talking only SBUS2. For ex. D-Power AVICON PRO
Is there a possibility to convert the telemtrie data to S-Port? using SBUS2 as sensor and S-Port as the target protocol
Regards…
-
Hi
I just updated my the IDE
C:\Users\bernt\AppData\Local\Arduino15\packages\esp32\hardware\esp32\3.0.0\cores\esp32\Arduino.h
And I'm getting this... can you help?
In file included from C:\U…
-
I have already successfully sent the RPM,EGT to jetcat's slot. But the status. I have tried to send the test status code. It doesn't respond to it. Why? Is there something preprocessing I miss before …
-
Hello,
is it possible to use this lib to read SBUS2 sensor data to Serial monitor / PC? o create a sort of sensor data sniffer.
i have an application where i like to take existing sensors data (sb…
-
I have successfully make it work on receiver R3001SB. However it can't work with R7108. The slot 8-slot 31 just can't work. But the slot0-slot7. Why?
I asked chatGPT what's the scheme of the sbus2. I…
-
We found that SBUS communication does not work with Futaba Receivers. We were able to track the issue down to the end byte. FrSky receivers use 0x00 as the end byte and this is how the code is setup c…
-
Hi
Something is wrong here.
I'm trying to sync 2 engines rpm with ESP32 (v2.0.17). Futaba T32MZ and R7008SB, only receiving channels and slots.
The display in the logg comes from Serial.prin…
-
There is a Bug for using ESP32 with this SBUS2 Library and write/read internal Flash
If ESP32 does a Flash read/write and a Interrupt occure (For Example receiving SBUS(2) or transmit Telemetry) th…
-
If the SBUS(2) Signal is broken (wire broken, disconnected or receiver unpowered) the SBUS_Ready() function would return true forever.
There should be a reset of sbus_ready and telemetry_ready.
…
-
Current the new UI buttons programming has wheels to select value button PWM output, the increments of this is very small at 1pwm and it takes long time to get to upper values.
Ideally this could…
MadRC updated
4 years ago