-
Hello, could You add some example how to use the serial protocol communication and binding please ?
Kind regards for help
Piotr
-
Hello,
I'm trying to communicate with a stepper motor through the rs485 serial pins on the 8 pin connector at the end of the arm. I'm using python and I can't figure out how to setup a serial connect…
-
-
Hello DobermannFW,
Thanks for sharing your code here.
Is it possible that you share a minimalist example just to understand the HART Telegram so that we can be confident with the packets of data tha…
-
### Creating a bug report/issue
#### Required Information
- DietPi version | v8.21.1
- Distro version | Bullseye and Bookworm
- Kernel version | `Linux DietPi 6.1.21-v8+ #1642 SMP PREEMPT Mon Ap…
-
A user writes:
my eshapeoko will be connected via a lantronix ethernet-to-serial converter.
Would you be interested in adding the possibility to connect to a tcp port via QTNetwork (instead of a seri…
-
The parity bit is not transmitted over the wire (checked with scope). I reduced the demo code form the win32comport_demo.py to:
```
from win32file import * # The base COM port and file IO function…
-
Hi!
Before I made patch, that add serial port communications and it was worked well. But I tested it with usb serial adapter.
Recently I used sg2002 based system with native hw uart and faced tha…
-
i have plugged in the FT232R breakout board which i think is needed for it to work with vixen but i cant seem to make it work what is the wiring diagram for this? what settings do i need for vixen?
-
# Observed behavior
From email from @Stephen-Lail: "I am trying to plot the GPS data I took the other day. In previous tests of the other sensors, I was inside so the GPS readout was always 0. I open…