-
I don't know if it's possible. But if it is, it would be awesome if the SmartPort connector on the transmitter could be used as a basic servo tester.
I figured it would be a tool in the system > con…
-
Hello everybody,
I wanted to drive a brushless motor with the 6-Pack CNC Controller and installed RC Servo/BESC CNC I/O Module on socket #4.
I programmed the BESC with a servo tester and then
wa…
-
There is a limited amount of linear actuators so we should test using basic servos similar to ones used in trial project. Not sure if a demo exists so might need to reach out to @AndrewDEmerson for gu…
-
ESC is Wraith32 Metal 60A V2.
Tested on BlHeli32 version 32.3 and 32.4
Steps to Repro:
1. Configure BLHeli with all failsafes off
2. Attach servo tester to ESC
3. Attach suitable motor to ESC
…
-
```
What new feature/ability do you want?
Would be nice to have the LOOP function for servo movement (similar as servo
tester).
Probably special mix, only with REPLACE function (MULTIPLEXING line).
…
-
```
What new feature/ability do you want?
Would be nice to have the LOOP function for servo movement (similar as servo
tester).
Probably special mix, only with REPLACE function (MULTIPLEXING line).
…
-
```
What new feature/ability do you want?
Would be nice to have the LOOP function for servo movement (similar as servo
tester).
Probably special mix, only with REPLACE function (MULTIPLEXING line).
…
-
```
What new feature/ability do you want?
Would be nice to have the LOOP function for servo movement (similar as servo
tester).
Probably special mix, only with REPLACE function (MULTIPLEXING line).
…
-
```
What new feature/ability do you want?
Would be nice to have the LOOP function for servo movement (similar as servo
tester).
Probably special mix, only with REPLACE function (MULTIPLEXING line).
…
-
```
What new feature/ability do you want?
Would be nice to have the LOOP function for servo movement (similar as servo
tester).
Probably special mix, only with REPLACE function (MULTIPLEXING line).
…