-
Update Si5351 drivers and test
They are currently old, and there is now an Arduino library that can be used.
-
I'm using Arduino 1.8.15.
In the "si5351wire.cpp" section I get an error when compiling "si5351_signal_generator2.ino"
.......
.......
Si5351wire::Si5351wire(uint8_t i2c_addr, uint8_t i2c_sda, uin…
-
I have tryed SI4735_2.8_TFT_SI5351_V3.5 with crystal and it runs nice.
Have then tried to use si5351 enabling it on:
//#define IhaveCrystal
#define IhaveSI5351
but its returning SI5351 not …
-
The connections in https://dl2man.de/wp-content/uploads/2023/07/truSDX_Main_1_2-1.pdf look like:
![Screenshot_2024-06-17_11-18-32](https://github.com/dawsonjon/PicoRX/assets/79528/f3656a9e-c3fc-422…
-
- PicoEZ-Mate connector is not the correct one: pitch of 1.00mm vs 1.20mm expected. The connector can be desoldered and a proper 1.20mm connector soldered.
- ~~SI5351 requires VCXO to be enabled to g…
-
Hi all, just putting this here as I am working on a driver for the Si5351. So far I have successfully set a specific set of frequencies based on the output from SiLabs software. Im basing the driver o…
-
Anyone tried to use this lib with Si5351? If so, pls share a code to encode/transmitt FT8. Thx in advance.
-
Hi Jason.
I have made a new .ino file within the map with the 4 minimal files.
The sketch is like this:
#include "si5351-avr-tiny-minimal.h"
#include "USI_TWI_Master.h"
void setup()
{
s…
-
The library does not seem to work with the new Microchip AtTiny's, at least with the AtTiny3216, but the Adafruit 5351 library does. I am using Arduino 1.8.15 and MegaTinyCore and the supplied example…
-
Is there a sample config.h where the si5351 board is running? I conncected a board to pin header of RS41 Ports 2 SDA and 3 SCL - see 3,8 volt on the VCC on si5351 - also set Si5351 CW on but see no si…