-
Hi, is there any pin that I can use for third thermistor sensor for heated chamber?
I tried Z stop and PS-on. No luck.
-
Trying to set up the SFS V2.0 on an SKR Mini E3 V3 and not sure of the wiring. The manual has the wiring from the SFS going to 2 pins on the E0DET and to 2 pins on the E1DET plugs and the SKR Mini E3 …
-
I want independent control of a fifth stepper driver for G34 bed leveling in Marlin by using the EXP-MOT v1 module. My SKR Mini E3 v3 is connected to a TFT35 E3 v3, and thus does not have an open EXP …
-
Hello,
I have an Ender 3 with an SKR Mini E3 V3, and I just bought the Micro Probe V2. I tried both firmware files from the firmware tab, but neither worked.
First, I tried the normal wiring wit…
-
Bonjour,
J'ai installer sont mon Ender 3 V2 une skr mini e3 v3 avec klipper.
J'ai bien flasher le firmware comme indiquer sur le github.
https://github.com/bigtreetech/BIGTREETECH-SKR-mini-E3/tre…
-
Hi if anyone has any suggestions it would be greatly appreciated. because i'm walking away from this otherwise. Thanks in advance..
I am trying to connect to my 3DP with a BTT skr mini e3 v3 board,…
-
Hi there,
I own an Ender 6 and wanted to get better prints, more and better settings and more information about printer and printings.
That's why I bought the BTT SKR Mini E3 V3.0 and the BTT TFT35…
-
I'm attempting to follow the instructions of the MicroProbe V2 manual, which is on this GitHub, and I've been running into error after error.
>note: this is the location of the previous definition
…
-
Hello
I'm trying to upload the bootloader on a SKR MINI E3 V3 i download the file and plug the bord via ST-Link and try to upload but when i do Program and Verify it says Canot disable Read Out Pr…
-
Can you add the Big tree tech "SKR MINI E3 V3.0' mainboard trays?