-
Smoothieware.org is offline with all related documentation.
-
Hello everyone,
i've been trying to get smoothieware running on SKR v1.3 for a few days now, but i couldn't. With Marlin everything works quite well, this means there is no problem with the hardwa…
-
Any chance you can update the firmware files for the Motionboard (rev B) to the current Smoothieware? and/or give some guidance on how to change and build Smoothieware to work with the Motionboard?
-
Helle,
is it planned to support smoothieware?
Best regards
Keule updated
4 years ago
-
Any chance for smoothieware implementation ? Would be superb
Thanks and sorry for bothering :) Great job
-
Hi,
i am trying to make fresh smoothieware work with TFT35 v2. The provided binaries here work - the display connects to board.
However if I use fresh binary from Smoothieware's github, everything w…
-
Hi.
Smoothieware is a GRBL port originally, and uses essentially the same protocol to communicate ( with some things missing )
It'd be very nice to make bCNC compatible, that'd make plenty of Smooth…
-
Hi @vespaman
If it's not too much trouble, I'd like to quiz you about your config a little.
1) I notice you've got two sets of actuators for the peelers, LPEELER, LPEELER12, RPEELER, RPEELER12.…
hydra updated
1 month ago
-
I am trying to set up a laser engraver with the smoothieware firmware and config files provided on the skr v1.3 Github page. I have enabled the laser module and set the pins for enabling the laser alo…
jr-11 updated
3 years ago
-
![resdet](https://user-images.githubusercontent.com/7695323/28793308-e41e2906-7632-11e7-8850-088678035d66.PNG)
Upon issueing the "reset" command, it will always happen that Smoothieware closes the …
ghost updated
6 years ago