-
Hi @TripitakaBC ,
thanks for your awesome Work on the Ampinvt MPPT Solar Controller.
I received my AP-60A Unit in the next Weeks and i will run the ESPHome with the ESP8266 MCU, that should also…
-
Something happened and my integration doesn't work anymore, not one Victron device is recognized. I recently updated firmware on all 4 devices, 3 solar charger controllers and 1 shunt. Not sure this i…
-
The Mayfly's Lipo battery solar charge controller chip ([MCP73831](https://www.microchip.com/wwwproducts/en/en024903#additional-features)) has a max output of 500 mA, which is about the 550 mA peak ou…
-
-
Hi
great project.
I am wondering if this will be enhanced by other Renogy products?
I understood that the DCC50S uses a different version RS485 and is not compatible with the ROVER
Thanks…
-
### Describe the bug
So the smart engine controller does suppose to turn on the car engine so it can recharge the battery when it's below the low threshold.
However in practice, it turns the engin…
-
Hi, I have a Vitodens200 with Vitotronic 200 combination connected via optpolink to HA and I am reading out information from it. My deviceID is 20CB. I also have a solar controller SM1 connected to th…
-
I have original PorMr POW-HVM6.2M-48V-N
And ESPhome shows Incorrect mode of sensor Charger Source Priority:
**Current incorrect mapping:**
CSO - utility first (should be solar first)
OSO - solar a…
-
So far, I have been working with a solar station that uses Epever MMPT charge controllers.
This year I upgraded froma Tracer 3210N to a Triron 4210N.
.
I use multiple scripts in python, php, htm…
-
It seems that the library detects a system consisting of multiple separate components only as one of these. In my case it is a CU401-B that is detected as gas heating but consists of (at least) a gas …