-
I am having trouble getting the solder to bridge the gap on the jumpers, any suggestions?
-
After I ordered PCB/PCBA and upload the production files to JLCPCB,
I got the following messages from JLCPCB.
> Soldering issue for some RC8、RC15、C15、RR4 parts - as advised by the engineer, there…
-
Great set. However: Just soldered with a beginner and it turns out that the paint on the circuit board is a bit thin. A short circuit can quickly occur at three points where plus and minus are close t…
-
The Sequre HT140 soldering tweezers has an OLED screen and is one of the newer models.
I hope it gets support on IronOS to improve reliability.
Chipset is
CKS32f103CBT6
NTF2F
2419
Seems tha…
-
Here is the issue they reported by email:
Is it legit and the PCB should be fixed here or are they doing…
-
Hi
I bought all the needed components, a very similar breadboard and I can print the enclosure.
I have a hard time translating the schematic and laying out all the components on a breadboard simul…
-
I got a Pinecil at the recommendation of IC and I haven't used it much yet but it seems fine?
blech updated
5 months ago
-
Ensure heating element is not able to touch any not solderable materials.
Electrical outlets and ventilation is secure
eye protection.
We have lead free solder now, so only with very extended solde…
-
**Kind of issue?**
_Assembly_
**Which Board?**
_RGB_
**Which Board Revision?**
RGB = 2.1
**What steps have you taken**
* [x] I have searched the Issues page
* [x] I have read the …
-
If resistors and capacitors could be changed to 0805 footprint it would be way easier to hand solder them. Hand soldering 0402 parts is an extreme sport ;) I'm not saying it's not doable, but for sure…