-
A lot of error Messages here:
![2023-08-16 09_29_32-soyosource](https://github.com/syssi/esphome-soyosource-gtn-virtual-meter/assets/102554708/e25a4d4c-4991-4630-b631-052556cea228)
WZBFL updated
11 months ago
-
Extend the WiFi dongle page by a "How to flash the alternative firmware" paragraph.
1. Backup the stock firmware
2. Flash the alternative firmware: `esphome run esp8266-wifi-dongle-example.yaml`
…
-
Hello o have a bunch of 36v lithio batteries and wnat to make usefulk on my solar system. I saw this inverter grid tie with limiter that are perfect except for the fact that is wired limited an my inv…
-
Excellent project!
Since it could have interesting industrial uses, it would be important to add Modbus access.
-
In the CLI output it says: "Using the new method of calculating the power demand" (which overshoots by quite a lot).
Is there a way to use the "standard method"?
I found out, that this is in soy…
-
See #45. Mention the pinout of the TTL-WIFI connector: 5V, TX, RX, GND
syssi updated
2 years ago
-
Good morning,
This is less of an issue for me and more of a question regarding the starting temperature of the fan.
Your code shows an active fan from 45°C. In my case, however, the fan switches t…
-
Hello,
I tought to give this tiny board esp32-c3-devkitm-1 a try, it is smaller and more powerful than esp8266.
I installed code from your repository.
Thanks for that.
It works in general but it …
-
I use as powermeter an 4Noks Elios4you device that update "bought power" every 60 seconds (positive only value).
When I put the esphome to auto limiter mode it switch to "Limiter operation mode: Inac…
cpiga updated
1 month ago
-
![image](https://user-images.githubusercontent.com/19148189/180763401-a1cca267-032c-4d25-a5c2-e632f8fae24b.png)
please see above
this is also being carried through into home assistant too.