-
### What happened
During automated configuration through the wizzard, select Performance Mode as well as StealthChop mode. The resulting configuration resulted in skipped steps during Z-tilt calibr…
-
I'm trying to work out how fast I can move the stepper motor on my platform (ESP32) using your library. As part of my testing, I modified the MoveAtVelocity example to test turning on/off StealthChop …
-
**Describe the bug**
Running `AUTO_SPEED AXIS=Z` on my voron 2.4 with tap sensor, it appears that all "missed steps" checks reported with 0.00 or 0.03. As a result it recommended the highest possible…
-
This looks brilliant. I will test it as soon as I can.
the esphome AC dimmer has hardware interrupts enabled. If you venture in more accurate timing. I am also working on a driver with precise timi…
-
### Wiki Search Terms
motor, stepper, limit, stallguard, config, configuration, tmc2130, Enable, Disable
### Controller Board
6-pack V1p8
### Machine Description
6 Individual Axis (Nema…
-
When my TMC2130 has stealthchop enabled with this library it seems to be reaching a threshold and not allowing the motor to go past a certain speed.
Disabling makes it work fine. I believe there is…
-
### What would you like implemented?
It would be great if M569 was integrated so you can see the Stealthchop mode Status and back it up before you flash firmware so you could restore that config.
##…
-
### Did you test the latest `bugfix-2.0.x` code?
No, but I will test it now!
### Bug Description
Stepper motors are noisy/vibrate at low, medium and high speeds (30mm/s, 60mm/s, 80mm/s, 120mm…
-
In older builds I could set the max run current for TCM2209 ([PLUGIN:Trinamic v0.16]) to 2000 mA:
```
Send: M122
Recv: [TRINAMIC]
Recv: X Z A B
Recv: Drive…
-
### What happened
I have hybrid hardware, and it was initially enabled, but due to doing some debugging I set it to CoreXY mode.
Rather than changing my wiring, instead when I changed to corexy, I…
evilC updated
2 weeks ago