-
Hi all,
Am using waveshare SX130x LoRaWAN Gateway Module/HAT for rpi 4.
I want to integrate the sx1302 lorawan packet forwarder with aws server it requires aws key, certifates, trust certificates.
…
-
Hi all!
Does chirpstack-gateway-bridge support the ability to connect Gateways built on the reference SX1302, SX1303?
The example configuration file itself says that it is intended for the SX130…
-
## Summary
We have been working with separate SX1302 binaries and chirpstack server for last a few months, it works well.
But is there any way to integrate IN865 in SX1302 chipset configuration fo…
-
I'm having difficulty getting my Seeed WM1302 (based on SX1302) SPI concentrator to start. It is mounted in the Seeed WM1302 Raspberry Pi HAT on a Raspberry Pi 4 (64-bit) running Raspberry Pi OS Lite …
-
In setting up my gateway (WM1302) I can't seem to get connected to the TTN servers with the following errors:
```
2024-05-24 14:50:37.318 [S2E:INFO] Beaconing every 2m8s on 923.3MHz(8) @ DR8 (fram…
-
A few of us have gotten an error lately when trying to use this [guide](https://github.com/maco2035/DiyHeliumHotspots/blob/master/RAK2287/Raspberry%20Pi%204B/Guide.md) to install the packet forwarder.…
-
Greeting,
I am encountering difficulties with GPS synchronization in the Lora gateway. My hardware setup is: Raspberry Pi 3B+ and SX1302 LoRaWAN Gateway HAT by waveshare. I've successfully connected…
-
Hi all again!) I am working with loragw driver (ported it to esp32), now I need additional info on how can be interrupts mapped in order:
1. RX done event. In [other discussion] https://github.com/Lo…
-
Hello everyone,
I'm encountering an issue with my LoRa setup in the Australia region. Here's my setup:
Device: ESP32 with SX1262 Waveshare module
Gateway: Raspberry Pi 4 with SX1303 915MHz, usi…
-
I cannot figure out which pins to set for the reset script.
spi and i2c are enabled.
tyro@rpiz:~/LR1302_loraWAN/LR1302_HAL/sx1302_hal/packet_forwarder $ ./reset_lgw.sh start
CoreCell reset thro…