-
I note that the subject Solar-MPPT-Charge-Controller explains the function of the inductor L1 as being there to smooth out the electric current heading for the battery. It says:
"_Then from the so…
CX500 updated
5 years ago
-
-
Hello Angelo,
Thank you very much for sharing this awesome project with the world. I learned a whole lot about synchronous buck converters and mppt, all thanks to your instructable.
I'm wonderin…
-
For future revisions, perhaps you could consider integrating in a boost converter to supply 24V to the heating element, such that the full 65W of power can be used. Perhaps the space freed by the barr…
-
Hi, I'm building a DC Bus design that skips the entire inverter process. Is there any documentation on using DC fast charging with this project?
Basically what I'm looking at doing is using this, i…
-
I'm wondering why Q2 gate is connected to LS_DRV signal. I'd have understood if it was connected to a STM32 GPIO as a way to prevent current flowing in reverse from the battery to the solar panel.
…
-
hi, i want to make a portable variable power supply controlled by esp32
i want to ask some question about the module
1. is the module synchronus aka there is 4 mosfet operating the inductor in full …
-
Hi,
I'm also am developing MPPT based on this project.
I've already designed my own PCB incorporating some of the hardware changes You mention in your notes (like low side shunt current sense an…
-
motionEyeOS version: 20180401 on Raspberry Pi Zero W with MMAL Camera
Connecting over WiFi
Unable to collect log files
While in normal operation (No other issues of defects apparent), after power…
-
Hi
I want add the Toshiba FlashAir W-04 16Gb (Wifi module + SD card)
https://www.flashair-developers.com/en/discover/overview/
in the ender3 with this microsd/SD adapter
![](http://img.d…