-
We want to display the output for one more thermocouple, and have some additional graphs on the 'Monitoring' tab to join the temperature graph. This could be the target setpoints and/or the PID output…
-
I have been using kiln controller to run an older kiln without issues for a couple of years.
I recently had an issue with the run ending at exactly the same time/temperature before I was unable to s…
-
# Current Implementation
Right now the thermocouple on the battery board is a AD8495 feeding into an ADS1015 I2C ADC. This has been working fine for us, but on the V3b spin of the boards the thermo…
-
When I test the TC with thermocople.py, the temperature values are unstable and I get the error messages ‘short circuit to ground’ and ‘short circuit to power’ between the measured values.
I have…
-
(This is @michele-riva, writing from the LT Lab)
Trying to measure `T ~ -140C` with a K thermocouple gave the following exception:
```
ERROR:root:Traceback (most recent call last):
File "C:\…
-
Hi, I tried compiling the sample code for Thermocouple and upon checking the serial monitor output, it only reads "nan". I've checked that the thermocouple is functional, connected properly to CH0 and…
-
# Description of the Issue
It seems that for some reason when using CircuitPython firmware the thermocouple ADC takes far too long to collect temperature readings.
# Example of the Issue
-
- [ ] design and document subcircuit. Add to master.
- [ ] using relevant subcircuit, demo sensor alone, verify accuracy
- [ ] Demo operating next to other sensors while logging to sd card compa…
-
Can anyone help me figure out why my EBB2240 is displaying -93 degrees for my Hotend temp? Im using a Rapido hotend and i think its Pt1000. I have tried using these settings
sensor_type:MAX31865
…
-
The thermocouples on ultratronics aren't working for me. I tried selecting -3 and -1 for the temp sensor and both times i get abnormal constant temp values 20000 and 329.9. I'm using the latest dev ve…