-
Hi there, thanks for the great walk through.
I bought a 7.5 inch Waveshare eink display that is 800x480 resolution, and it doesn't seem to work.
I first tried using the Pimoroni 7.3 setup, but…
-
Not sure if this is the right place to put this but hoping for support for Raspberry Pi 4B + WaveShare 3.52. i've attached the installation log from putty
[Bjorn - Pi 4B with 3.52 log.txt](https://gi…
-
Hi,
I got this error during compilation, sketch line 208:
'TXT_FORECAST_VALUES' was not declared in this scope. Any help on where I should investigate.
My conditions:
OS: Linux MX-23
Ardu…
-
First of all, thank you very much for providing this library, which allows me to successfully run waveshare's ESP32-S3-Touch-LCD-4.3
I am a beginner. I don't know much about custom development boar…
-
### Description
If interested i can offer to add/provide a description, instruction on howto get a non FTI Waveshare RS485 (B) serial to usb adapter model to work properly with Homeassistant and th…
-
Could you please add support for this device?
https://www.waveshare.com/wiki/Modbus_POE_ETH_Relay
Thanks in advance!
-
I'd like to redesign the rev2.0 Pico-Timecode board to be as cost efficient as possible, so am reviewing Picos.... I could lay out a complete design with RP2040/RP2350, but that would make the build m…
-
Using a clean Pi4 install and making the lib path change noted in the other open issue, results in the following error
Using 7.5 inch epaper red/black screen
Traceback (most recent call last):…
-
Hello everyone,
I have a problem getting my ESP32 to work with this LCD using the TFT_eSPI library—it always shows a black screen (just the backlight is on).
**Details:**
- IDE: PlatformIO
- T…
-
### The problem
I recently bought [this](https://www.amazon.com/gp/product/B075R4QY3L/) Waveshare e-ink display with [this](https://www.amazon.com/gp/product/B07M5CNP3B/) ESP32 driver board. I'm tr…