-
Please consider adding the ability to control how often WSPR beacons are transmitted using the web GUI as can be done from the command line.
For example, to transmit one WSPR beacon on the 30M band…
AA7US updated
5 months ago
-
Hello, I am looking to make a config for 144mhz wspr but when i enter the frequency in the config generator I always have error
pll.c should be in range [1 ... 1048575]
How does one enter the…
-
Hi,
I was thinking about how to maximise the use of the limited four receiver resources in each KiWi, especially when not being used by remote listeners.
I note that the KiWi currently has the I…
G8JNJ updated
6 years ago
-
I have built a single band RPi WSPR shield which is successfully transmitting. I would like to design a multi band shield, where each band is generated by a different GPIO pin. How many distinct pins …
-
Eg, it was recieved by a wspr reciever X km away when conneted to X antenna and transmitting on frequency X
-
Hello,
What modulation is supported by this firmware for APRS?
-
Greetings,
I just installed Wsprry Pi 1.2.0 on a trusty old Pi 3 using a fresh download copy of 32 bit Raspberry Pi OS Legacy (Bullseye). The install of Wsprry Pi went fine.
After configuring t…
AA7US updated
5 months ago
-
Attempting to run some wspr beacons by using the command line and have encountered a new error:
**terminate called after throwing an instance of 'std::filesystem::__cxx11::filesystem_error'
what…
AA7US updated
5 months ago
-
I am 100' from my WSPR beacon, which is getting over 700 spots per day.
The instructions beautifully built the rtlsdr_wsprd
GQRX loudly hears both my WSPR beacon and the pico-cw-beacon in my at…
-
I am using FreeDATA with Ft897D and Pulse audio device.
When I transmit (Beacon, CQ or simply Tune test) I am unable to lower ALC level without lowering power level.
Same behavior using pavucontro…