MPCNC-SKR1.3-TMC2208UART

Modified Marlin 2.0 firmware for the BigTreeTech SKR1.3 with TMC2208 UART drivers for the MPCNC. Includes dual end stops.

Features:

Compatibility with SKR1.3 from BigTreeTech
Immediate compatibility with TMC2208 in UART mode with Stealthchop and driver monitoring enabled
Works with the MPCNC with 5 motors via 5 stepper drivers and with end stops enabled
Marlin M122 enabled to allow diagnostics of TMC drivers
Babystepping is enabled to allow slight Z changes when running a project
Uses the heated bed pins as the "fake" extruder (so these are not available for use)

Possible changes to use with your MPCNC: Marlin\configuration.h

If you have 3 wire end stops or your end stop isn't working as expected in Marlin\configuration.h change true/false on the appropriate ENDSTOP_INVERTING from lines 639 to 645
If you have a 16tooth pulley then you are good to go. If you have a 20 tooth then edit line 720 to have the values of 80, 80, 400, 80
You can change X_BED_SIZE and Y_BED_SIZE on lines 1054 and 1055 to match your cutting area to assist the firmware with not allowing you to crash once homed (I have not gotten software max endstops to work perfectly yet) Marlin\Configuration_adv.h
If your motors aren't moving the axis the same direction go change INVERT_X2_VS_X_DIR or INVERT_Y2_VS_Y_DIR from true to false (or flip the motor wires). If both motors are working as they should but going the wrong way check lines 1022-1024 in Configuration.h (or flip the motor wires)

To use:

Download all the files
Open as a PlatformIO project in either Atom or Microsoft VSCode
Make edits as required
Build or build/upload the project
Install microsd card in the SKR1.3 if you didn't directly upload and then reset the SKR1.3

Source info:

Changelog:

BlomsD / MPCNC-SKR1.3-TMC2208UART