search

DCC-EX / Support-Planning

DCC++EX Repo to hold project planning documentation and processes
1 stars 1 forks source link

Ticket Submitted via Website #60- WiFi Issue #60

Closed fire-bot closed 1 year ago

fire-bot commented 3 years ago

Sent by (mkakasapu@gmail.com). Created by fire.

Steve created a ticket

Name: SteveWare

Email: seware74@gmail.com

Timezone: -6

Software: CommandStationEx

Version: 3.0.0

Title: Stuck in station mode

Description: I have been working on getting WIFI control on my MEGA2560 command station. I started with AP mode on version 3 Beta 1 of the software. This worked out of the box initially. When I went back to it yesterday. I could not connect to the command station with 'engine driver' on my phone (as I had done successfully sunday and monday). I decided to try station mode. I edited the config file with my wifi info and reloaded the station. The station appeared to connect to my home wifi, but engine driver could not connect: 'timeout waiting for VN message'. I decided to try to go back to AP mode, but cannot. I set the WIFI info in config.h back to default and loaded it on the board. After it comes up I try to issue +CWQAP in the serial monitor, but there is no response. Following the boot sequence in the monitor, it is still trying to boot into station mode, and is still trying to use the home wifi IP. This is the makerfabs WIFI board suggested on the setup site. I also tried with 3.0.0 beta 2. Same results. Any thoughts on how it can be stuck in station mode? And why it might ignore the command to clear WIFI parameters?

Remaining email Quota: 99

Asbelos commented 3 years ago

Did you include the <> around the cmd?On 18 Nov 2020 15:02, Fire notifications@github.com wrote: Sent by (mkakasapu@gmail.com). Created by fire.

Steve created a ticket Name: SteveWare Email: seware74@gmail.com Timezone: -6 Software: CommandStationEx Version: 3.0.0 Title: Stuck in station mode Description: I have been working on getting WIFI control on my MEGA2560 command station. I started with AP mode on version 3 Beta 1 of the software. This worked out of the box initially. When I went back to it yesterday. I could not connect to the command station with 'engine driver' on my phone (as I had done successfully sunday and monday). I decided to try station mode. I edited the config file with my wifi info and reloaded the station. The station appeared to connect to my home wifi, but engine driver could not connect: 'timeout waiting for VN message'. I decided to try to go back to AP mode, but cannot. I set the WIFI info in config.h back to default and loaded it on the board. After it comes up I try to issue +CWQAP in the serial monitor, but there is no response. Following the boot sequence in the monitor, it is still trying to boot into station mode, and is still trying to use the home wifi IP. This is the makerfabs WIFI board suggested on the setup site. I also tried with 3.0.0 beta 2. Same results. Any thoughts on how it can be stuck in station mode? And why it might ignore the command to clear WIFI parameters? Remaining email Quota: 99

—You are receiving this because you are subscribed to this thread.Reply to this email directly, view it on GitHub, or unsubscribe.

ldribin commented 3 years ago

Asbelos: Did you send an email to the Requester? He may not have seen your response on GitHub.