Clock runs slow after switching to calculating dial position by seconds

Duckle29 / Hollow-Clock-ESP

An ESP8266 or ESP32 firmware for the Hollow Clock

4 stars 0 forks source link

Clock runs slow after switching to calculating dial position by seconds #1

Closed Duckle29 closed 3 years ago

Duckle29 commented 3 years ago

This is an issue I found after updating the code to also work on ESP32 boards. While I'm not sure the error is in the degree calculation, I do think it's there.

Duckle29 commented 3 years ago

It might just be that my motor is skipping steps, as I'm using a 12v motor on a 5v supply

Duckle29 commented 3 years ago

Seems to just have been an issue with skipping steps