If this issue is not a bug report or improvement request, please check the Dynamo forum, and start a thread there to discuss your issue.
Dynamo version - 1.3.0.875
(Which version of Dynamo are you using? Go to Help > About if you're not sure.)
Revit version - 17.0.1099.0
(Which version of Revit are you using?)
Operating system - Win7 SP2
(e.g. Windows 7, Windows 8.1, etc)
What did you do?
Using the node Select Rule Type, I set the drop-down value to "Equals"
At some point later, the drop-down is blank and the node turns red.
The error message above the node is shown in the attached file.
Haven't determined the exact cause yet. I'll update if I can reproduce at will.
If this issue is not a bug report or improvement request, please check the Dynamo forum, and start a thread there to discuss your issue.
Dynamo version - 1.3.0.875
(Which version of Dynamo are you using? Go to Help > About if you're not sure.)
Revit version - 17.0.1099.0
(Which version of Revit are you using?)
Operating system - Win7 SP2
(e.g. Windows 7, Windows 8.1, etc)
What did you do?
Using the node Select Rule Type, I set the drop-down value to "Equals" At some point later, the drop-down is blank and the node turns red. The error message above the node is shown in the attached file.
Haven't determined the exact cause yet. I'll update if I can reproduce at will.
What did you expect to see?
(Fill in here)
What did you see instead?
(Fill in here)