If this issue is not a bug report or improvement request, please check the Dynamo forum, and start a thread there to discuss your issue.
Dynamo version
Dynamo Core 2.12.1.8246
Dynamo Revit 2.12.1.8411
Revit version
2022.1.3
Operating system
Windows 10
What did you do?
I try to select a face
What did you expect to see?
A selected Face Without error
What did you see instead?
An error "Warning: Conversion of one or more geometries failed due to the following error: trim_with_edge_loops requires that all curves touch the surface"
If this issue is not a bug report or improvement request, please check the Dynamo forum, and start a thread there to discuss your issue.
Dynamo version
Dynamo Core 2.12.1.8246 Dynamo Revit 2.12.1.8411
Revit version
2022.1.3
Operating system
Windows 10
What did you do?
I try to select a face
What did you expect to see?
A selected Face Without error
What did you see instead?
An error "Warning: Conversion of one or more geometries failed due to the following error: trim_with_edge_loops requires that all curves touch the surface"