GreenMobi BMS - A BMS board compatible with the VESC BMS firmware
The VESC BMS board system is under closed development at the time of this writing although the BMS firmware is publicly available so this project consists on a VESC compatible BMS board that is able to run VESC BMS firmware.
This project is under development and the board is not yet ready. KiCAD is being used for the board's design and contributions are welcome.
Desing approach
Since there is not yet a opensource design of a VESC fully compatible BMS this board is being designed with ease of development in mind so it can be used as a reference design to contribute directly to the VESC project and extend its potential. So the following principles are followed:
- Popular and easy to source connectors are used (JST PH, screw terminals, etc) even if in most end uses it would be better to have weatherproof panel connectors.
- SMD packages optimized for JLC assembly or PnP on premises (down to 0402 passives).
- Daisychaining multiple AFEs and ESD protection are targeted to a second iteration of the design.
Here it is a block diagram of the design:
Contributions
Since the design is at a schematic phase, it would be helpful if you can review the board's schematic to look for misconnections and erros using any of the given ICs. However, any other kind of productive feedback and work is welcome. Be sure to read the design approach so your contributions match the goals of the project.
Credits
This project is meant to be interoperable with the VESC, which is a registred trademark, held by Benjamin Vedder and the BMS firmware and its hardware design hints that are in it that this designs follows are of Benjamin Vedder's authoring.