DIY Split-Flap Display

This project is a work in progress and is based on Scott Bez's project found here. The project is aimed around building a low cost split flap module that could be joined to others to form a display. So far the internsion is to get multiple units dasiy chained togeather for a one line display then will work on integrating it for a particular purpose.

Most current enclosure design	Highlights of design
	Uses easy to find M4 hardware in standard sizes 3D printable frame that can also be laser cut Uses cheap 28BYJ-48 stepper motors Incorperates hall effect sensor for homing the display Low cost Far sturdier than v1 frame Less complex spool mechanisim