Goldfish-clone-JLCPCB

This board is a new layout for the original Goldfish by Lucas Jansen.

REV A has several design issues that make it very difficult to attach the USB connector.

Do not use!

Why?

This board was designed to be used with JLCPCB's SMD assembly service. Because JLCPCB has very different requirements, the board layout needed redesigned entirely.

Important changes

• Four layer board with separate ground and power layers. No additional charge, so why not?
• Board is wider to meet the minimum width requirements
• The board is longer to allow top-side labels all the way around
• Changed the USB connector to one that is more easily soldered by hand at the cost of making the board slightly thicker.
• Changed the crystal to match parts available.
• 0 Ohm resisters added to help USB data signal routing
• Additional USB Datapins removed.

License Information

Released under the Creative Commons Attribution Share-Alike 4.0 License.
https://creativecommons.org/licenses/by-sa/4.0/

Original Arduino Mini Design by Team Arduino.
Arduino Pro Mini Design by Spark Fun Electronics.
Pro Micro Design by Spark Fun Electronics.
Goldfish Design by Dr Derivative.
JLCPCB assembly version by Jeremy J Starcher

Revision History

• Rev A - Initial release. On order - untested.