MarcoGos / davis_vantage

Davis Vantage custom component integration for Home Assistant
5 stars 0 forks source link
davis-weatherlink home-assistant weather-station

Davis Vantage

hacs release downloads

This is a custom integration for the Davis Vantage Pro2. Either use a serial port or use an ip adress to connect to your device.

Model Compatible
Davis WeatherLink SER (6510SER) Yes
Davis WeatherLink USB (6510USB) Yes
Davis Weatherlink IP (6555IP) Yes
WeatherLink Live No
Davis Weather Envoy8X (6318EU) No
Other models Unsure

Every readout takes up about 20-25 seconds. So intervals smaller than 30 seconds are not available.

Installation

Via HACS, just search for Davis Vantage.

Setup

During the setup of the integration the serial port or the hostname of the weather station needs to be provided.

Example network host: 192.168.0.18:22222

If you're not sure about the port number (usually port 22222), then browse to the ip address of the IP logger and look at the port number on the configuration page.

What to expect?

The following entities will be created:

Diagnostic entities:

The entity information is updated every 30 seconds (default or other value is choosen otherwise during setup).

Known problems

During first setup the communication to the weather station can be a bit tricky, resulting in an error saying the device didn't communicate. Please try again to set it up (can take up to 5 times).

If Wind Gust doesn't show a value or "Unknown" make sure the Davis time is set correctly. You can check this by using service "Davis Vantage: Get Davis Time" and, if necessary, correct it by using service "Davis Vantage: Set Davis Time".

It's unsure if Vantage Vue is working. Please contact me if this integration is working so I can add it again.