Open mfc123 opened 10 years ago
Try to flash with the automatic selection of protocol.
Also does it say "no gps" or "no fix" ?
Will try flash later with auto protocol.
It say No fix, 0 sat.
If it say "No fix", flashing with auto protocol will not help (since GPS already detected and works). Just go outside and try in the field.
The gps was detected and the green led on the crius is flashing like it was searching for sat's.
It was outside, and in the same place that my apm with the same gps get a fix.
U-center will show status / number of sat's etc. After a crash I had a broken antenna that caused my GPS fail searching the needed sat's for a fix. Whats the baudrate and serial port you use?
That copter never had any crash and it was flashed with the flash tool, so i think it is the default serial and baudrate...
Did you solve it?
Not yet...flashed again with auto protocol and again no sat. It is searching for sats but sats always at 0.
I would have connected U-center and tested the GPS. Do you have a FTDI? You can also use a program like Minigps 1.4 to read your gps on a computer.
I dont have fdti cable...I solved tje issue with an eeprom clear and a reflash. Gps is working again!
yay, please close this issue, if everything is resolved, thank you.
I have flashed MPNG 3.1.5 r2 on my crius aiop v1 with my cn-06 gps with the flash tool and set the gps protocol to ublox and can't get any sat with about 20min test... What can be the problem? Thanks