Open GrCommando opened 9 years ago
smurfy
commented
9 years ago MultiWiiConf / WinGUI_2.2
is for multiwii and does not work with ardupilot/mpng.
MissionPlanner on the other hand should work. Are you sure you selected the correct serial port and baudrate (115200)?
GrCommando
commented
9 years ago Thank God!!!!!
i use terminal and works
then i change the speed to 115200 and all good :)
Thank you so much!
Now Im dealing With another problem.... my tx/rx are ok (bind) but i can't calibrate my radio, as mission planer doesn't receive any signal :( i try some settings in RC input :but nothing Tx: Turnigy 9XR Rx: frsky V8fr II
Also GPS baudrate 57600 it ok?
smurfy
commented
9 years ago good to hear that the connection works now.
the radio problem useally is that you need to swich from ppm to pwm input. just try with the flashtool.
regarding gps. the default is 57600 but for example one of my gps modules runs at 115200.
GrCommando
commented
9 years ago Yeahhhhh!!!! Everything looking good now!!! Now i have to explore the settings and make my quad stable as rock :thought_balloon: :smile: Lucky me, the guy that sold me the Crius V2 has upload the latest u blox code ;) now runs 115200!!! Thanks smurfy !!!!
Unfortunately i was trying to connect my Crius AIO V2 to mission planner... I update my firmware to ArduCopter V3.1.5. After this it cant conect MultiWiiConf / WinGUI_2.2 and MissionPlanner-1.3.7. Before this was possible to connect to MultiWiiConf / WinGUI_2.2. I do all the possible scenarios to change my firmware again, I did it with the new flashtool1_0rc2 and manually many times. I can see data transferring while firmware updating, but when i try to connect and read the board... nothing happens :( Please help me im trying 6 hours reading and trying to found what happend )
( im using the same cable)