Creality CR10S PRO ( and others Marlin FW compatible 3D printers )

- ATTENTION! This is already a very old version ..
- I don't have as much time as I would like for this project ..
- so I don't recommend using this project .. use them at your own risk!

- Hey! This code is still a Work in Progress! Files, instructions, and other stuff might change!

+ This project includes Marlin FW + DWIN Addon code and DWIN display source code

• Small pass through the development of Custom DWIN you can watch on YouTube PC-maniak :movie_camera:.

  ! Version :
  ! DWIN Addon / DWIN Source code : 0.3
  ! Marlin 1.x : 1.1.x "bugfix" snapshot Patches after 1.1.9

- I am looking for a volunteer graphic designer to make graphic adjustments
- and a new graphic background to make the graphic better fit

• Working on this project is really hard :feelsgood: if you want to support me .. you can here :pizza:.

+ TODO LIST (please report any identified deficiencies and bugs so I can fix them - add to TODO)

• [ ] Marlin 2.0 support -> 80%
• [x] Protection -> 100%
• [ ] USB flash drive support -> 60%
• [ ] ESP32 for email/phone info -> 40%
• [x] DWIN FAN Speed control -> 100%
• [x] DWIN M117 TEXT -> 100%
• [ ] DWIN Flow rate control -> 10%
• [x] DWIN Advanced menu -> 100%
• [ ] DWIN Editable "Preheat profile" -> 10%

  ! Write your ideas in the "issues" section

- Pre-required :

• Creality CR10S PRO
• or
• 3D printer with Marlin FW.
• DWIN Display(With TOUCH!): DMT48270C043_06W.
• Optional :
• JST XH2.54 Wire(6Pin!): JST-Wire-Cable-Plug.
• Crimper Dupont Piler(I recommend the whole set): DuPont-2.54.

+ Installation :

• Marlin + Addon :

• I recommend using VScode + PlatformIO !

Video tutorial : YouTube PC-maniak.

1) Install VSCode 2) Open Extension(CTRl+SHIFT+X) a type PlatformIO 3) Hit install 4) Follow the installation instructions 5) Enjoy ;)

++++++++++++++++++++++++++++++++++++++++++++++++++++++

• DWIN Display SW :

Video tutorial : YouTube DWIN TUT.

0) ! Optional edit DWIN_SET with DGUS Tools

- if you make a change and generate a new DWIN_SET you must run FIX NAME.BAT !!

1) Copy DWIN_SET to root of SD card 2) Put sd card into lcd! sd card slot 3) Turn ON Power and wait until on LCD show END process 4) take out SD card .. 5) Enjoy ;)

++++++++++++++++++++++++++++++++++++++++++++++++++++++

• DWIN Display HW (only for use on printers other than the CR10S Pro):

• if communication is not working .. change the RX and TX position
• it must be connected to UART2 on the printer board
• if you must use a UART port other than 2, you must change the port number in the DWIN addon code
• UART2 should be free but in the next update I will modify the code to a simple definition port number

++++++++++++++++++++++++++++++++++++++++++++++++++++++

+ Tested on :

• Creality CR10S PRO
• Board GT2560 rev a+
• Board GT2560 rev a

• if you try the code on another board / printer please write your experience in the "issues" section