3030 Haribo Edition

credit: @arobe

Unaffiliated Statement

We are not affiliated with Prusa Research and the work hereafter was done independently / derived from open source files

We are not affiliated with any Facebook group, any one claiming the haribo mod / haribo3030 / zaribo mod / etc is doing so on their own and it's not part of the effort

The ONLY official source is this github and the ONLY official channel to reach us is listed below (mattermost).

Contact us

Please join our Mattermost if you want to reach us.

There is a lot of different topics / channels on there, we welcome all with open arms.

Disclaimer

you do this modification at your own risk

we are not responsible for any damages / injuries that might arise from the usage of all material, including but not limited to ideas, documentation, diagrams, that you get from this github. All precautions and safety protection should be taken and only attempt it if you are experienced in this area.

Introduction

Inspiration for the project came from davtr mk2 conversion Prusa i3 MK2-X

The use of 3030 extrusion makes the frame very rigid and square. It takes a lot of the guess work out of building the MK2

The name is from the candy that we get when we buy the MK2 kits. Somebody jokingly said that's a good name and it sort of stuck.

We welcome any contribution to the project, just open a PR (pull request) and we will review and merge changes

Haribo in the wild

S3D base settings

• 60mm/s 60% other speeds 30% first layer speed
• 80mm/s 50% other speeds 25% first layer speed
• 100mm/s 40% other speeds 20% first layer speed
• 120mm/s 30% other speeds 15% first layer speed