This is an library for PN532 to use NFC technology. It is for NFC Shield and Grove - NFC.
Easy way
Git way for Linux/Mac (recommended)
Get PN532 library and NDEF library
cd {Arduino}\libraries
git clone --recursive https://github.com/Seeed-Studio/PN532.git NFC
ln -s NFC/PN532 ./
ln -s NFC/PN532_SPI ./
ln -s NFC/PN532_I2C ./
ln -s NFC/PN532_HSU ./
ln -s NFC/NDEF ./
Follow the examples of the two libraries
It's based on Adafruit_NFCShield_I2C. Seeed Studio rewrite the library to make it easy to support different interfaces and platforms. @Don writes the NDEF library to make it more easy to use. @JiapengLi adds HSU interface. @awieser adds card emulation function.
HSU is short for High Speed Uart. HSU interface needs only 4 wires to connect PN532 with Arduino, Sensor Shield can make it more easier. For some Arduino boards like Leonardo, DUE, Mega ect, there are more than one Serial
on these boards, so we can use this additional Serial to control PN532, HSU uses 115200 baud rate .
To use the Serial1
control PN532, refer to the code below.
#include <PN532_HSU.h>
#include <PN532.h>
PN532_HSU pn532hsu(Serial1);
PN532 nfc(pn532hsu);
void setup(void)
{
nfc.begin();
//...
}
If your Arduino has only one serial interface and you want to keep it for control or debugging with the Serial Monitor, you can use the SoftwareSerial
library to control the PN532 by emulating a serial interface. Include PN532_SWHSU.h
instead of PN532_HSU.h
:
#include <SoftwareSerial.h>
#include <PN532_SWHSU.h>
#include <PN532.h>
SoftwareSerial SWSerial( 10, 11 ); // RX, TX
PN532_SWHSU pn532swhsu( SWSerial );
PN532 nfc( pn532swhsu );
void setup(void)
{
nfc.begin();
//...
}