search

SpaceTeddy / CC1101

driver library for Ti CC1100 / CC1101. For Arduino and Raspberry Pi
MIT License
271 stars 92 forks source link

Trying to receive signal from CCdebugger and smartRF studio #16

Closed Bob1237 closed 5 years ago

Bob1237 commented 6 years ago

Hello

FIrst let me tell you i am a complete noob to raspberry and cc1101 , so i don't know a lot about it. But i was wondering if it was possible to use your code to receive a signal with the raspberry pi and cc1101 send by smart RF studio and the ccdebugger. Because I have followed your readme file and did everthing like you said , but i don't receive anything , and i am using the same frequentcy , modulation ,... My problem is similar to the one were you talk about inthe issues: Not Receiving Anything #11 but nothing he did there works for me.

if you know anything about this let me know

Thanks

BoB1237

SpaceTeddy commented 6 years ago

Hi Bob, thanks to try my library.

May you please post some terminal output logs of the RX_Demo and TX_Demo? In addition, detailed pictures of your hardware Setup are helpful!

Thank you,

Kind regards, Chris

Bob1237 commented 6 years ago

hello

this is my terminal output : image

and here are picture of the connection but i don't think there something wrong whith that because i connect it exactly the same like you. (sorry for the bad picture) image image image

first one is from the transmitting end

Sorry for the late rasponds

Bob

SpaceTeddy commented 6 years ago

Dear Bob,

your register settings looks not correct and you used non valid command line parameters. May you please follow the example command line parameters? try: sudo ./RX_Demo -v -a3 -c1 -f434 -m100 (receiver address 3; channel 1; frequency 434; modulation 100kbit GMSK)

I've never used this CCdebugger. Unfortunatly I can not help you.

SpaceTeddy commented 6 years ago

did you try again to keep it running?