search

TedTolboom / hk.com.remotec

Athom Homey app repository for Remotec Technology devices (Z-wave)
MIT License
3 stars 6 forks source link

Unable to add zxt-120 to homey #22

Open grotting opened 6 years ago

grotting commented 6 years ago

When trying to include the ZXT-120 to the homey, it stops on retrieving command class 9/10 and says that no z-wave device has been found. If you try again, it says that it is already paired.

TedTolboom commented 6 years ago

Hi, So the inclusion process was not completed.

Can you take the following (default) steps to recover:

  1. Remove the ZXT-120 by going to Settings > Z-wave > remove device and follow instructions; it should indicate “successfully removed device”
  2. Manually reset the ZXT-120 to default according to the procedure provided in the manual
  3. Move the ZXT-120 in close range of Homey
  4. Try inclusion again
grotting commented 6 years ago

I tried the suggested actions, but it still did not work. However i tried to change the mode from FLIRS to Always on, powering it from a usb powerbank, and then I managed to get it connected. I would prefer to be able to connect it in FLIRS mode though.

TedTolboom commented 6 years ago

@grotting I just updated the ZXT-120 driver / app... Although I don't expect it will have impact on the issue not being able to connect it in FLIRS mode...

I'll do some additional tests later this week to see if I can find the issue..

danone1973 commented 6 years ago

@TedTolboom when in FLiRS mode, it took me several attempts to include the ZXT-120. It kept getting stuck at various steps when retrieving command class. Eventually the process was complete. When in always listening mode, it included straight on every time.

Distance Homey-ZXT less than 1m. No other z-wave devices included in Homey.

TedTolboom commented 6 years ago

@grotting @danone1973 with the release of Homey firmware 1.5.13-rc.11 to experimental, it should now be possible to include the ZXT-120 / ZXT-600 in FLiRS mode..

[Z-Wave] Fixed a bug that could prevent Z-Wave S2/FLiRS nodes from pairing

Can you check and confirm?