SV07 Klipper Config

I recently got an SV07 and immediately proceeded to mess up my config (accidentally changed a pin). I then had an incredibly hard time getting a stock copy of the config from Sovol and could not find it anywhere online.

So to help others that may run into the same issue (and myself when I inevitably need it again) I am uploading my config here including some changes I have made.

Changes

This is not the stock config but the changes I have made I feel improve the UX of the printer.

These changes include:

• Changing the hot end LED to be a toggle not a brightness slider. The stock config had the PWM frequency set to a 5 second cycle so you couldn't control brightness anyway.
• Added a macro for toggling the hot end LED.
• Added an override for M106 and M107 to also use the large fan on the back.
• Added a toggle that enables and disables the large fan (this requires the Virtual Pins klipper module). When switched off it will turn the fan off and when switched on it will set the fan to the same speed as the normal extruder fan.

SuperSlicer Config

I have added my SuperSlicer config for the SV07, this is a modified version of the SV06 config recently added to Pruser Slicer. Since I am mostly focusing on quality I have not tuned these print settings for speed. I have also only tested the 0.2mm layer height preset but the rest should work.

I also used the bed texture and model from the SV06. The config is set to use the files from Pruser Slicer if they are there but if not I have included the svg and stl files here as well.