This repository only supports the non-touch version of T-Display-S3-AMOLED. Touch version is not supported. For the touch version, please go to LilyGo-AMOLED-Series
This repository was created by @mmMicky earlier, LilyGo-AMOLED-Series also supports the non-touch version. For the non-touch version, it can be used in two Choose between warehouses
T-Display-S3-AMOLED is an ESP32-S3 development board. Equipped with a new AMOLED high-resolution color LCD screen and 2 programmable keys. Communication adopts SPI or QSPI interface. Keep the same layout design as T-Display. You can directly use ESP32S3 for USB communication or programming.
T-Display-S3-AMOLED is available from: [LILYGO](), [Amazon]() and [Aliexpress]().
The board uses USB as the JTAG upload port. When printing serial port information on USB, CDC_ON_BOOT configuration needs to be turned on. If the port cannot be found when uploading the program or the USB has been used for other functions, the port does not appear. Please enter the upload mode manually.
https://raw.githubusercontent.com/espressif/arduino-esp32/gh-pages/package_esp32_index.json
URL in the Additional boards manager URLs
input box. C:\Users\YourName\Documents\Arduino\libraries
)The installation method varies depending on the system, refer to the official manual for installation.
SPI
(CS, MOSI, SCLK, DC) interface. One is to use the QSPI
method (CS, SCLK, D0, D1, D2, D3). The QSPI method can increase the driving speed by four times compared with the SPI. to fit the larger screen.
The board uses USB as the JTAG upload port. When printing serial port information on USB_CDC_ON_BOOT configuration needs to be turned on. If the port cannot be found when uploading the program or the USB has been used for other functions, the port does not appear. Please enter the upload mode manually.
If the above is invalid, burn the binary file to check whether the hardware is normal