Product(PinMap) | SOC | Flash | PSRAM | Resolution |
---|---|---|---|---|
T-Display-S3-Pro | ESP32-S3R8 | 16MB | 8MB(OPI) | 222x480 |
examples
βββ examples/Arduino_GFX_HelloWorld # Arduino_GFX example
βββ examples/Arduino_GFX_LvglBenchmark # Arduino_GFX example
βββ examples/Arduino_GFX_PDQgraphicstest # Arduino_GFX example
βββ examples/CameraShield # Camera example
βββ examples/CapacitiveTouch # Capacitive Touch example
βββ examples/LTR553ALS_Sensor # Light & Proximity Sensor example
βββ examples/TFT_eSPI_Simple # TFT_eSPI example
βββ examples/USB_HID_Example # USB Host HID & OTG example
βββ examples/UnitTest # Hardware unit testing example
βββ examples/PMU_Example # Power management settings and battery information detection example
βββ examples/AdjustBacklight # Backlight adjustment example
βββ examples/Cellphone # With camera that can take pictures, to view the photos in the album (sd card required)
βββ examples/factory # Factory example
If use the 'examples/Cellphone' examples,
be careful not block the top of the "S3-Pro" screen, if it is blocked, the screen will sleep.
PlatformIO
plugin in the VisualStudioCode
extension and install it.VisualStudioCode
VisualStudioCode
, select File
in the upper left corner of VisualStudioCode
-> Open Folder
-> select the T-Display-S3-Pro
directoryplatformio.ini
file, and in the platformio
columndefault_envs = xxxx
to make sure only one line worksT-Display-S3-Pro
to DecktopTools
, Look at the picture to choose
T-Display-S3-Pro
-> examples
-> any examples
-> any eaxmples.ino
Port
upload
, Wait for compilation and writing to completeThe board uses USB as the JTAG upload port. When printing serial port information on USB_CDC_ON_BOOT configuration needs to be turned on. If the port cannot be found when uploading the program or the USB has been used for other functions, the port does not appear. Please enter the upload mode manually.
If the above is invalid, burn the binary file to check whether the hardware is normal
The OTG external power supply function requires turning on the PMU OTG enablement. If the USB input is connected and the OTG is set to output, the battery will not be charged.
Turning the physical switch to OFF will completely disconnect the battery from the motherboard. When charging is required, turn the switch to ON.
When the battery is not connected and the USB is plugged in, the board's LED status indicator light will flash. You can use PMU.disableStatLed();
to turn off the indicator light, but this means that if the battery is connected for charging, the LED light will also be disabled. If you need to enable the charging status indicator, please call PMU.enableStatLed();
Device shuts down suddenly?