When i add everything to the config and upload the sketch to my nodemcu the homebridge app shows the device ass "not supported" by the home app.
I checked the ip address and everything else i know off.
Did i forgot anything to set it up properly ?
Do i need the "platform" or "python" part ?
The servo is the same ure using and its connected right.
Im relatively new to homebridge so excuse me for any stupid questions. :)
When i add everything to the config and upload the sketch to my nodemcu the homebridge app shows the device ass "not supported" by the home app. I checked the ip address and everything else i know off. Did i forgot anything to set it up properly ? Do i need the "platform" or "python" part ? The servo is the same ure using and its connected right.
Im relatively new to homebridge so excuse me for any stupid questions. :)