Will Enable Work With a DMM DYN2 Servo Controller

clough42 / electronic-leadscrew

Lathe electronic leadscrew controller

MIT License

323 stars 117 forks source link

Will Enable Work With a DMM DYN2 Servo Controller #214

Open frostheave1960 opened 2 years ago

frostheave1960 commented 2 years ago

Hi All,

As shown below, Enable (Pin 11) is Positive and has a Negative Common (Pin 7). The diagram for the ELS PCB shows a Positive Common. Will it be possible to use Enable with this drive?

Thanks for your help!

DYN2-Diagram

pmelevende commented 2 years ago

HI Frostheaven,

Yes - Check 'Direction and Enable' on this page https://github.com/clough42/electronic-leadscrew/wiki/Configuration-Settings

Thanks Pauly

frostheave1960 commented 2 years ago

Very good. Thanks Pauly.

And just to be sure, I won't be doing any damage to the hardware by physically reversing the polarity to the Enable lines, Correct?

Thanks again Bob

pmelevende commented 2 years ago

HI again Bob

No you will be fine. Even if you mess up somehow, I'd assume that 270 ohm resistor on the enable line is there to protect you :-). Having said that , if you are worried, check the polarity before you connect it!

Thanks Pauly