Arduino - RFM69 based sensors and MQTT gateway
May 2016: Published a Wifi connected ESP8266 node here: https://github.com/computourist/ESP8266-MQTT-client
- it uses the same message format as the RFM nodes
- it is a direct mqtt client, no gateway needed
- RFM and ESP nodes can be mixed in the same setup
================
March 2016: corrected swapped NSS signals in schematics for gateway 2.4
================
February 2016: added schematics for gateway 2.4 and DHT end node
================
January 2016: published Gateway version 2.4:
- this version is now compatible with Arduino IDE again
- DEBUG function split into an MQTT and a radio part. Debugging can be done one at a time. This solves memory constraints.
================
November 2015: Openhab example added, showing the use of node-generated status messages to sync Openhab with local output toggles.
================
Changes in Gateway version 2.3:
- implemented system device 9: number of retransmissions needed in the radio link
- removed some of the debug code as a result of memory constraints
Version compatibility:
RFID has not been upgraded yet since the code is not stable. (it will work -unstable- with GW2.3 though)
Changes in Gateway version 2.2:
- changed handling of binary input devices to improve compatibility with Openhab
- improved RSSI reporting
Changes in Gateway version 2.1:
- uniform handling of binary input devices
- transparant exchange of string data (device 72) added
- minor bug fixing
Changes in Gateway version 2:
- increased data exchange data block
- implemented standard device numbering
- removed leading spaces in decimal sensor data
- implemented uptime counter
- implemented error checking & reporting
- implemented uptime and version reporting in gateway
The setup consists of two types of devices:
- an end node that measures parameters, changes output states and communicates over radio with a central gateway
- a gateway node that connects to end node over wireless and publishes/receives MQTT messages to/from a broker.
The communication between MQTT broker and multiple end nodes is duplex, meaning:
- The state of an end node device/parameter can be queried thru the broker at any time
- The end node has outputs, so external devices can be controlled over MQTT
- Sensor commands can be acknowledged by the end node
- Loss of radio signal to a certain end node is indicated to the MQTT broker
- End nodes can send sensor data on regular intervals, on incoming query or event-based
- MQTT message syntax can easily be altered by only changing the gateway code
- Multiple end nodes can be addressed by a single gateway
Communication between gateway and nodes is over an encrypted wireless link and handshake mechanisms are used to guarantee succesfull transmission. Radio link errors are reported to the MQTT broker.
Communication between gateway and MQTT broker is over fixed ethernet.
The end node software is capable of:
- switching one or more outputs (LED, relay)
- measuring temperature, humidity, battery voltage
- set transmission interval in seconds
- switch off automatic regular transmission
- report software version
- report radio signal strength
- monitor button presses
- set button action to local toggle, local timer or generation of an MQTT event message
- set button press timer interval in seconds
The gateway software is capable of:
- Communicating with end nodes and with the MQTT broker
- Automatically set up connetions tp MQTT broker and end nodes
- Translate the internal message format to MQTT messages and vice versa
- Detect radio signal loss and report this to the MQTT broker
- Publish end node events in a northbound message stream
- Subscribe to a southbound message stream to receive, parse messages and address the corresponding end node
- Manually produce event queries in debug mode